The enterprise to create roller equipment when the harsh execution of the requirements of their own

The enterpriseundefineds current production of roller equipment harsh use of strict standards to strictly rely on the execution of their own requirements, sure to obtain the most effective supply for customers, high-quality supplies. The manufacturing process is currently described as follows:

1, the original materials, pipes, bearings, punches this kind of several but very influential. The important original material of roller performance and check regulation, assume round jump, straightness, etc., therefore, relative to the current selection of the above accessories but strict quality control, should be done in place under the basic circumstances, so to start the customer.

2, press, should be the best way can not eccentric press in the best way to reduce the runout of the company in the construction of roller equipment, are often used to carry roller finished inspection.

Relatively, there are the following main ways of testing:

1, V-type iron supporting roller shaft, using magnetic meter seat to measure circle runout, straightness, concentricity 

2, rotary resistance experiment, use test bench, The recommended tooling 

3, axial load test and drop test 

4, soaking test, this experiment is usually OK, unless waterproof requirements, the inner structure of the roller is not quite the same. Relative affirmation of the best way for roller wall thickness, bearings using row, row seal.

If punching bearing seat is welded, idler and pipe welding the best way of uniform, complete, sealed! In addition, rollers can not be used in their environment, more maintenance, life can be extended, relative to the absolute thickness of roller wall, you should personally test. And core quality assurance, outside adhesive layer adhesion, hardness, wear resistance to obtain standard requirements by execution.